Did anyone has a wifi cut sometimes ?

Hichem B. #564
Hichem B. #564 Posts: 55 ✭✭
in Internet
Hey Guys
Hope you're doing well , question plz , sometimes i have a cut on my wifi when im round 10 to 15m from my router, is there anyone who's experiencing same problem ??
thanks for your replay :)

Answers

  • DinoS
    DinoS Posts: 626 ✭✭
    Use 5g only may help
  • Hichem B. #564
    Hichem B. #564 Posts: 55 ✭✭
    Thanks for your replies , so i'm not the only one ,
    @Tom I did use only the 5g it didn't help ,
    @MT How can i turn off ATF on fizz router , if you could just make a resume plz
  • M T. #338
    M T. #338 Posts: 2,934 ✭✭
    It should be in wireless settings .
  • Francois O. #1209
    Francois O. #1209 Posts: 4 ✭✭
    I have the same problem.
    You found a solution?
  • Hichem B. #564
    Hichem B. #564 Posts: 55 ✭✭
    @Francois , no i didn't most of time it is good , till now
  • Whizz
    Whizz Posts: 23,047 admin
    Hi Hichem,
    This is a known issue with some customers - This should be fixed by tomorrow morning :)
    Jay
  • kwenchana
    kwenchana Posts: 25 ✭✭
    My WIFI is also acting wonky, I set a specific WIFI channel known to have less interference on the 2.4Ghz and it would change channel on its own, I was using those channels just fine with my Bell Hub 2000 before.
    Same for 5Ghz, you can set a channel and bandwidth but the modem will change on its own!!
    Tried 20Mhz on ISM channel 165...next day it's back to 36... ISM and UNI-3 shouldn't be even be a DFS channels so I'm not sure what is going on.
    When I enabled DFS, I expect to be able to use UNI-2 channels but no, only UNI-1 36-48 (which have lower max output signal than channel 149+) and UNI-3 and ISM.
    Tried 149 at 80Mhz...sometimes jump to 161 and/or set itself to 40Mhz.
    Currently on 40Mhz ch 161, lots of Bell Fibe modem/receivers hogging ch 149...so i'm trying to avoid interferences
This discussion has been closed.

Categories