Did anyone has a wifi cut sometimes ?

Hichem B. #564

Hey Guys
Hope you're doing well , question plz , sometimes i have a cut on my wifi when im round 10 to 15m from my router, is there anyone who's experiencing same problem ??
thanks for your replay

ReneD

Apparently, modem's WiFi is not very efficient. Some users gave up and installed third party WiFi router.
Check if there is a firmware update available for the modem or a setting to increase signal strength.
Chizz )

M T. #338

Turn off ATF would help improving wifi experience.

DinoS

Use 5g only may help

Hichem B. #564

Thanks for your replies , so i'm not the only one ,
@Tom I did use only the 5g it didn't help ,
@MT How can i turn off ATF on fizz router , if you could just make a resume plz

M T. #338

It should be in wireless settings .

Francois O. #1209

I have the same problem.
You found a solution?

Hichem B. #564

@Francois , no i didn't most of time it is good , till now

Whizz

Hi Hichem,
This is a known issue with some customers - This should be fixed by tomorrow morning
Jay

kwenchana

My WIFI is also acting wonky, I set a specific WIFI channel known to have less interference on the 2.4Ghz and it would change channel on its own, I was using those channels just fine with my Bell Hub 2000 before.
Same for 5Ghz, you can set a channel and bandwidth but the modem will change on its own!!
Tried 20Mhz on ISM channel 165...next day it's back to 36... ISM and UNI-3 shouldn't be even be a DFS channels so I'm not sure what is going on.
When I enabled DFS, I expect to be able to use UNI-2 channels but no, only UNI-1 36-48 (which have lower max output signal than channel 149+) and UNI-3 and ISM.
Tried 149 at 80Mhz...sometimes jump to 161 and/or set itself to 40Mhz.
Currently on 40Mhz ch 161, lots of Bell Fibe modem/receivers hogging ch 149...so i'm trying to avoid interferences