Did anyone has a wifi cut sometimes ?
Hichem B. #564
Posts: 55 ✭✭
in Internet
Hey Guys
Hope you're doing well , question plz , sometimes i have a cut on my wifi when im round 10 to 15m from my router, is there anyone who's experiencing same problem ??
thanks for your replay
Hope you're doing well , question plz , sometimes i have a cut on my wifi when im round 10 to 15m from my router, is there anyone who's experiencing same problem ??
thanks for your replay
6
Answers
-
Apparently, modem's WiFi is not very efficient. Some users gave up and installed third party WiFi router.
Check if there is a firmware update available for the modem or a setting to increase signal strength.
Chizz) 7 -
Turn off ATF would help improving wifi experience.5
-
Use 5g only may help3
-
-
It should be in wireless settings .2
-
I have the same problem.
You found a solution?2 -
@Francois , no i didn't most of time it is good , till now2
-
Hi Hichem,
This is a known issue with some customers - This should be fixed by tomorrow morning
Jay3 -
My WIFI is also acting wonky, I set a specific WIFI channel known to have less interference on the 2.4Ghz and it would change channel on its own, I was using those channels just fine with my Bell Hub 2000 before.
Same for 5Ghz, you can set a channel and bandwidth but the modem will change on its own!!
Tried 20Mhz on ISM channel 165...next day it's back to 36... ISM and UNI-3 shouldn't be even be a DFS channels so I'm not sure what is going on.
When I enabled DFS, I expect to be able to use UNI-2 channels but no, only UNI-1 36-48 (which have lower max output signal than channel 149+) and UNI-3 and ISM.
Tried 149 at 80Mhz...sometimes jump to 161 and/or set itself to 40Mhz.
Currently on 40Mhz ch 161, lots of Bell Fibe modem/receivers hogging ch 149...so i'm trying to avoid interferences3
This discussion has been closed.
Activity feed
Page 1
Categories
Top contributors
this week
@Mike RZMAXSupreme Geek 5/5
86pts
@SuperFrizzApprentice 2/5
71pts
@wenhanSupreme Geek 5/5
68pts
